tsdumper2 ========= tsdumper2 reads incoming mpeg transport stream over UDP/RTP and then records it to disk. The files names are generated based on preconfigured time interval. License ======= tsdumper2 is released under GNU GPL v2. Development =========== The development is done using git. tsdumper2 repository is hosted at http://github.com/gfto/tsdumper2 To clone the repository issue the following commands: git clone git://github.com/gfto/tsdumper2.git cd tsdumper2 git submodule init git submodule update make The code is developed and tested under modern Linux. It is also compiled from time to time under OS X but is not tested there. To see all Makefile targets run 'make help'. Updating the code ================= To update cloned tsdumper2, go to the directory where the repository is cloned and run the following commands: git fetch origin git merge origin/master git submodule update make clean all tsdumper2's master branch should always be useful so it is safe to use it instead of official release. The master branch will always be better than any released version. Command line parameters ======================= tsdumper2 is controlled using command line parameters. For more information about the parameters see the man page. Here is a list of supported command line parameters: Usage: tsdumper2 -n -i Settings: -n --prefix | Filename prefix. -s --seconds | How much to save (default: 60 sec). -d --output-dir | Startup directory (default: .). -D --create-dirs | Save files in subdirs YYYY/MM/DD/HH/file. Input options: -i --input | Where to read from. . -i udp://224.0.0.1:5000 (v4 multicast) . -i udp://[ff01::1111]:5000 (v6 multicast) . -i rtp://224.0.0.1:5000 (v4 RTP input) . -i rtp://[ff01::1111]:5000 (v6 RTP input) -z --input-ignore-disc | Do not report discontinuty errors in input. -4 --ipv4 | Use only IPv4 addresses. -6 --ipv6 | Use only IPv6 addresses. Examples ======== To get a quick start here are some example command lines. Examples: # Read multicast stream from 239.78.78.78:5000 and save it in # files with test- prefix tsdumper2 --input udp://239.78.78.78:5000/ --prefix test # Same as above but create directories YYYY/MM/DD/HH and put # files into the directory. tsdumper2 --input udp://239.78.78.78:5000/ --prefix test --create-dirs # Same as above but create directories YYYY/MM/DD/HH and put # files into the directory and create new file each 10 seconds. tsdumper2 --input udp://239.78.78.78:5000/ --prefix test --create-dirs --seconds 10 Reporting bugs ============== If you think you have found bug in tsdumper2, please report it to the e-mail listed in Contact section (see below) of this README file. Releases ======== Official releases can be downloaded from tsdumper2 home page which is http://georgi.unixsol.org/programs/tsdumper2/ Contact ======= For patches, bug reports, complaints and so on send e-mail to Georgi Chorbadzhiyski